Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Gas tungsten arc welding

Related publications (29)

Design guidelines for remote laser welding in automotive assembly lines

Jumyung Um, Ian Anthony Stroud

Remote laser welding which has benefits for both productivity and energy saving is receiving increased attention for automotive assembly lines. Introducing this innovative equipment requires a redesign process for assembly elements, for example to substitu ...

Springer London Ltd2017

Ion cyclotron resonance heating for tungsten control in various JET H-mode scenarios

Jonathan Graves, Javier García Hernández

Ion cyclotron resonance heating (ICRH) in the hydrogen minority scheme provides central ion heating and acts favorably on the core tungsten transport. Full wave modeling shows that, at medium power level (4MW), after collisional redistribution, the ratio o ...

2017

Ultra low cycle fatigue of welded steel joints under multiaxial loading

Albano António De Abreu E Presa De Castro E Sousa

Extreme loading scenarios such as earthquakes, exceptional wind gusts or tides are characterized by very high amplitude and multidirectional cyclic loads applied to a structure. Ultra Low Cycle Fatigue (ULCF) arises in such cases and can be summarily defin ...

EPFL2017

Influence of geometrical imperfections and flaws at welds of steel liners on fatigue behavior of pressure tunnels and shafts in anisotropic rock

Alexandre Jean Pachoud

The recent development of high-strength (HSS) weldable steels has enlarged the range of design alternatives for the optimization of high-head steel-lined pressure tunnels and shafts (SLPT&S) in the hydropower industry. With the liberalization of the Europe ...

EPFL2017

Robotic Assistance by Impedance Compensation for Hand Movements While Manual Welding

Aude Billard, Mustafa Suphi Erden

In this paper, we present a robotic assistance scheme which allows for impedance compensation with stiffness, damping, and mass parameters for hand manipulation tasks and we apply it to manual welding. The impedance compensation does not assume a preprogra ...

Institute of Electrical and Electronics Engineers2016

Proposed modeling approach of welding procedures for heavy steel plates

Dimitrios Lignos

A numerical modeling approach is proposed to assess the effectiveness of automatic submerged arc welding procedures for steel plates with thickness larger than 50 mm. The scope of study includes partial joint penetration butt welds, their numerical analysi ...

Elsevier2016

New parametric equations to estimate notch stress concentration factors at butt welded joints modeling the weld profile with splines

Anton Schleiss, Pedro Filipe De Almeida Manso, Alexandre Jean Pachoud

For fatigue life estimation as well as for fatigue testing analysis of welded structures by local stresses approaches, the stress concentration factor (SCF) at the weld must be known. Full penetration butt welded joints are extensively used in steel struct ...

Elsevier2016

Parasitic Absorption Reduction in Metal Oxide-Based Transparent Electrodes: Application in Perovskite Solar Cells

Christophe Ballif, Stefaan De Wolf, Björn Niesen, Monica Morales Masis, Sylvain Nicolay, Jérémie Werner, Ali Dabirian

Transition metal oxides (TMOs) are commonly used in a wide spectrum of device applications, thanks to their interesting electronic, photochromic, and electrochromic properties. Their environmental sensitivity, exploited for gas and chemical sensors, is how ...

Amer Chemical Soc2016

Rapid screening tests for supplementary cementitious materials: past and future

Karen Scrivener, Ruben Anton Snellings

Rapid screening tests for supplementary cementitious materials (SCMs) have been in use for over 150 years. Over the years a multitude of methods have been put forward to predict the strength development of SCMblended mortars and concrete. This paper summar ...

Springer2016