Concept

RS-485

RS-485, also known as TIA-485(-A) or EIA-485, is a standard, originally introduced in 1983, defining the electrical characteristics of drivers and receivers for use in serial communications systems. Electrical signaling is balanced, and multipoint systems are supported. The standard is jointly published by the Telecommunications Industry Association and Electronic Industries Alliance (TIA/EIA). Digital communications networks implementing the standard can be used effectively over long distances and in electrically noisy environments. Multiple receivers may be connected to such a network in a linear, multidrop bus. These characteristics make RS-485 useful in industrial control systems and similar applications. RS-485 supports inexpensive local networks and multidrop communications links, using the same differential signaling over twisted pair as RS-422. It is generally accepted that RS-485 can be used with data rates up to 10 Mbit/s or, at lower speeds, distances up to . As a rule of thumb, the speed in bit/s multiplied by the length in metres should not exceed 108. Thus a 50-meter cable should not signal faster than 2 Mbit/s. In contrast to RS-422, which has a driver circuit which cannot be switched off, RS-485 drivers use three-state logic allowing individual transmitters to be deactivated. This allows RS-485 to implement linear bus topologies using only two wires. The equipment located along a set of RS-485 wires are interchangeably called nodes, stations or devices. The recommended arrangement of the wires is as a connected series of point-to-point (multidropped) nodes, i.e. a line or bus, not a star, ring, or multiply connected network. Star and ring topologies are not recommended because of signal reflections or excessively low or high termination impedance. If a star configuration is unavoidable, special RS-485 repeaters are available which bidirectionally listen for data on each span and then retransmit the data onto all other spans. Ideally, the two ends of the cable will have a termination resistor connected across the two wires.

Official source

https://en.wikipedia.org/wiki/RS-485

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related courses (32)

MATH-410: Riemann surfaces

This course is an introduction to the theory of Riemann surfaces. Riemann surfaces naturally appear is mathematics in many different ways: as a result of analytic continuation, as quotients of complex domains under discontinuous group actions, as algebraic ...

EE-320: Analog IC design

Introduction to the design of analog CMOS integrated circuits at the transistor level. Understanding and design of basic structures. ...

EE-100: Electrical engineering science & technology

Ce cours propose une introduction aux sciences et technologies de l'électricité en mettant l'accent sur les composants des circuits électriques. L'enseignement comprend à la fois une partie théorique avec un cours et des exercices, ainsi qu'une partie expé ...

Related publications (1)

EcoWikiRS: Learning Ecological Representation of Satellite Images from Weak Supervision with Species Observations and Wikipedia

The presence of species provides key insights into the ecological properties of a location such as land cover, climatic conditions or even soil properties. We propose a method to predict such ecological properties directly from remote sensing (RS) images by aligning them with species habitat descriptions. We introduce the EcoWikiRS dataset, consisting of high-resolution aerial images, the corresponding geolocated species observations, and, for each species, the textual descriptions of their habitat from Wik

IEEE2025

Graph Chat

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.

Official source

https://en.wikipedia.org/wiki/RS-485

About this result

Related courses (32)

MATH-410: Riemann surfaces

EE-320: Analog IC design

Introduction to the design of analog CMOS integrated circuits at the transistor level. Understanding and design of basic structures. ...

EE-100: Electrical engineering science & technology

Related lectures (32)

Common Transmitter Assembly: Configurations EC, BC, CC MOOC: Electronics II

Covers common transmitter assembly configurations and small signal analysis.

Serial Communications: Part One

Explores material aspects and protocols of serial communications in microcontrollers, covering encoding, baud rates, protocols like NRZI and Manchester, and the importance of serial transmissions.

Harmonic Forms: Main Theorem

Explores harmonic forms on Riemann surfaces and the uniqueness of solutions to harmonic equations.

Related publications (1)

EcoWikiRS: Learning Ecological Representation of Satellite Images from Weak Supervision with Species Observations and Wikipedia

IEEE2025

Related people (6)

Félix Schmidt

Teaching & PhD Courses Environmental impact assesment ENG-474 Presentation of the bases of the environmental impact assesment (EIA), context. Assesment methodology and tools for each of the topics and chapters. Illustration with many real cases, and group work. Discussion of the limitations of EIA and new tools such as strategic environmental studies.

Volkan Cevher

Volkan Cevher received the B.Sc. (valedictorian) in electrical engineering from Bilkent University in Ankara, Turkey, in 1999 and the Ph.D. in electrical and computer engineering from the Georgia Institute of Technology in Atlanta, GA in 2005. He was a Research Scientist with the University of Maryland, College Park from 2006-2007 and also with Rice University in Houston, TX, from 2008-2009. Currently, he is an Associate Professor at the Swiss Federal Institute of Technology Lausanne and a Faculty Fellow in the Electrical and Computer Engineering Department at Rice University. His research interests include machine learning, signal processing theory, optimization theory and methods, and information theory. Dr. Cevher is an ELLIS fellow and was the recipient of the Google Faculty Research award in 2018, the IEEE Signal Processing Society Best Paper Award in 2016, a Best Paper Award at CAMSAP in 2015, a Best Paper Award at SPARS in 2009, and an ERC CG in 2016 as well as an ERC StG in 2011.

Martin Vetterli

Martin Vetterli was appointed president of EPFL by the Federal Council following a selection process conducted by the ETH Board, which unanimously nominated him. Professor Vetterli was born on 4 October 1957 in Solothurn and received his elementary and secondary education in Neuchâtel Canton. He earned a Bachelor’s degree in electrical engineering from ETH Zurich (ETHZ) in 1981, a Master’s of Science degree from Stanford University in 1982, and a PhD from EPFL in 1986. Professor Vetterli taught at Columbia University as an assistant and then associate professor. He was subsequently named full professor in the Department of Electrical Engineering and Computer Sciences at the University of California at Berkeley before returning to EPFL as a full professor at the age of 38. He has also taught at ETHZ and Stanford University. Professor Vetterli has earned numerous national and international awards for his research in electrical engineering, computer science and applied mathematics, including the National Latsis Prize in 1996. He is a fellow of both the Association for Computing Machinery and the Institute of Electrical and Electronics Engineers and a member the US National Academy of Engineering. He has published over 170 articles and three reference works. Professor Vetterli’s work on the theory of wavelets, which are used in signal processing, is considered to be of major importance by his peers, and his areas of expertise, including image and video compression and self-organized communication systems, are central to the development of new information technologies. As the founding director of the National Centre of Competence in Research on Mobile Information and Communication Systems, Professor Vetterli is a staunch advocate of transdisciplinary research. Professor Vetterli knows EPFL inside and out. An EPFL graduate himself, he began been teaching at the school in 1995, was vice president for International Affairs and then Institutional Affairs from 2004 to 2011, and served as dean of the School of Computer and Communication Sciences in 2011 and 2012. In addition to his role as president of the National Research Council of the Swiss National Science Foundation, a position he held from 2013 to 2016, he heads the EPFL’s Audiovisual Communications Laboratory (LCAV) since 1995. Professor Vetterli has supported more than 60 students in Switzerland and the United States in their doctoral work and makes a point of following their highly successful careers, whether it is in the academic or business world. He is the author of some 50 patents, some of which were the basis for start-ups coming out of his lab, such as Dartfish and Illusonic, while others were sold (e.g. Qualcomm) as successful examples of technology transfer. He actively encourages young researchers to market the results of their work.

Paul Joseph Dyson

Paul Dyson joined the Institute of Chemical Sciences and Engineering at the EPFL in 2002 where he heads the Laboratory of Organometallic and Medicinal Chemistry and between 2008 and 2016 chaired the Institute. He has won several prizes including the Werner Prize of the Swiss Chemical Society in 2004, the Award for Outstanding Achievements in Bioorganometallic Chemistry in 2010, the Centennial Luigi Sacconi Medal of the Italian Chemical Society in 2011, the Bioinorganic Chemistry Award of the Royal Society of Chemistry in 2015, the European Sustainable Chemistry Award of the European Chemical Society in 2018 and the Green Chemistry Award from the Royal Society of Chemistry in 2020. He is also a Clarivate Highly Cited Researcher and has an H-index >110 (web of science and google scholar). He was elected a Fellow of the Royal Society of Chemistry in 2010, a Fellow of the European Academy of Science in 2019 and a life-long fellow of the American Association for the Advancement of Science in 2020. Over the years he has held visiting professorships at the University of Bourgogne, University of Pierre et Marie Curie, University of Vienna, University of Rome Tor Vergara, Chimie Paristech and Shangai Jiao Tong University.Since 2016 he has been Member of the Council of the Division of Mathematics, Natural and Engineering Sciences at the Swiss National Science Foundation.Between 2016-2021 he has been Member of the Council of the Division of Mathematics, Natural and Engineering Sciences at the Swiss National Science Foundation. In 2021 he was appointed Dean of the Faculty of Basic Sciences.

Cosimo Aprile

Franck Vincent

Related concepts (11)

Multidrop bus

A multidrop bus (MDB) is a computer bus in which all components are connected to the electrical circuit. A process of arbitration determines which device sends information at any point. The other devices listen for the data they are intended to receive. Multidrop buses have the advantage of simplicity and extensibility, but their differing electrical characteristics make them relatively unsuitable for high frequency or high bandwidth applications.

Serial Peripheral Interface

Serial Peripheral Interface (SPI) is a de facto standard (with many variants) for synchronous serial communication, used primarily in embedded systems for short-distance wired communication between integrated circuits. SPI uses a main–subnode architecture, where one main device orchestrates communication by providing the clock signal and chip select signal(s) which control any number of subservient peripherals. Motorola's original specification uses four wires to perform full duplex communication.

CAN bus

A Controller Area Network (CAN bus) is a vehicle bus standard designed to allow microcontrollers and devices to communicate with each other's applications without a host computer. It is a message-based protocol, designed originally for multiplex electrical wiring within automobiles to save on copper, but it can also be used in many other contexts. For each device, the data in a frame is transmitted serially but in such a way that if more than one device transmits at the same time, the highest priority device can continue while the others back off.

Related MOOCs (1)

Electronics II

This course is an introduction to the realization of linear functions using transistors. Students apply circuit theory and learn to manipulate the small and large signal models of the bipolar transistor to realize amplification and filtering functions. The explanations are illustrated by exercises with demonstrations of simulated circuits using a Spice-type simulator that can be reproduced by the students.

Related notebooks (2)

Building a Dual-Tone Multi-Frequency (DTMF) Decoder using Short-Time Fourier Transform

Dual-tone multi-frequency (DTMF) signaling[1]¶

                                      [2]Paolo Prandoni, [3]LCAV, EPFL

In this notebook we will build a dual-tone multi-frequency decoder based on the short-time Fourier transform. In [1]:

first our usual bookkeeping

%matplotlib inline import matplotlib import matplotlib.pyplot as plt import numpy as np import IPython In [2]: plt.rcParams["figure.figsize"] = (14,4)

Introduction[4]¶ DTMF signaling is the way analog phones send the n

Filtering Music: Extracting Audio Frequencies Using Filters

Filtering Music[1]¶

                                      [2]Paolo Prandoni, [3]LCAV, EPFL

In this notebook we will design and use filters to extract specific audio frequencies from a music file. In [1]: %matplotlib inline import matplotlib.pyplot as plt import numpy as np import IPython import scipy.signal as sp from scipy.io import wavfile infringment...) In [2]: IPython.display.Audio(s, rate=SF) Out[2]: Your browser does not support the audio element.

Extracting the bas