Home

Topics in geotechnical engineering

Applied sciences
Civil engineering
Geotechnical engineering
Topics in geotechnical engi...

About
Privacy
Disclaimer

Graph Chatbot

Related publications (31)

Influence of depositional fabric on mechanical properties of naturally deposited sands

Gioacchino Viggiani, Edward Carlo Giorgio Andò

Fabric characteristics and shear deformation behaviour were analysed in four intact small-scale samples, including two disturbed and two undisturbed samples of naturally deposited sand from a shoal in the San Francisco Bay. Triaxial compression tests were ...

ICE PUBLISHING2022

Experimental quantification of 3D deformations in sensitive clay during stress-probing

Edward Carlo Giorgio Andò

Unique four-dimensional (4D) deformation data are collected during drained triaxial tests on intact specimens of a natural sensitive clay. This requires the development of a miniature triaxial cell for advanced stress path testing, specifically designed fo ...

ICE PUBLISHING2022

Drained Axial Pipe-Soil Resistance at Low Confinement Using Tilt Table and Direct Shear Tests

Roba Houhou

Establishing a reliable value for the axial pipe-soil interface resistance is critical for the design of offshore pipelines. Over the last few years, several independent research groups have modified existing methodologies or devised new testing setups to ...

ASCE-AMER SOC CIVIL ENGINEERS2022

Life cycle environmental assessment of retaining walls in unsaturated soils

Alessio Ferrari, Gianluca Speranza

Retaining structures above groundwater level support soils that are usually in a state of partial saturation and subject to the actions of atmospheric agents. The current design approach considers the possible extremes of soil conditions - either totally d ...

ELSEVIER2022

Transport barrier in 5D gyrokinetic flux-driven simulations

Two ways for producing a transport barrier through strong shear of the E x B poloidal flow have been investigated using GYSELA gyrokinetic simulations in a flux-driven regime. The first one uses an external poloidal momentum (i.e. vorticity) source that lo ...

IOP Publishing Ltd2022

Freezing-induced stiffness and strength anisotropy in freezing clayey soil: Theory, numerical modeling, and experimental validation

Gioacchino Viggiani, Edward Carlo Giorgio Andò

This paper presents a combined experimental-modeling effort to interpret the coupled thermo-hydro-mechanical behaviors of the freezing soil, where an unconfined, fully saturated clay is frozen due to a temperature gradient. By leveraging the rich experimen ...

WILEY2022

Shear Response of Wet Weak Carbonate Rock/Grout Interfaces Under Cyclic Loading

Eleni Stavropoulou

The development and construction of offshore wind farms requires the correct estimation of the friction that can be mobilised at the rock/grout interface. In conventional studies, the shear behaviour of a joint is usually investigated with laboratory tests ...

2021

Discussion on "Experimental Deformation of Opalinus Clay at Elevated Temperature and Pressure Conditions: Mechanical Properties and the Influence of Rock Fabric" of Schuster, V., Rybacki, E., Bonnelye, A., Herrmann, J., Schleicher, AM, Dresen, G

Lyesse Laloui, Alessio Ferrari, Eleonora Crisci

The testing procedure and results on saturated samples of Opalinus Clay in the work of Schuster et al. (Rock Mech Rock Eng https://doi.org/10.1007/ s00603-021-02474-3, 2021) were conducted and presented using strain rates two to four orders of magnitudes h ...

2022

Benchmark study of undrained triaxial testing of Opalinus Clay shale: Results and implications for robust testing

Lyesse Laloui, Alessio Ferrari, Alberto Minardi

Triaxial testing of argillaceous rocks and shales is significantly more challenging than conventional rock mechanical testing. The challenges are mainly related to the very low permeability of these geomaterials, and their sensitivity to exposure of atmosp ...

ELSEVIER2021

Particle-size segregation and rheology coupling in dense granular flows

Tomás Alfredo Trewhela Palacios

Dense granular flows -debris or pyroclastic flows, avalanches, granular flows in heaps, silos or rotating drums-are ubiquitous to many natural and industrial processes. Their grain composition is often polydisperse, with particles differing in shape, size ...

EPFL2021

Cyclic thermomechanical behaviour of pile-soil interface and design methods for energy pile foundations

Elena Ravera

Energy piles are shallow geothermal systems integrated into structures already required for structural functions of civil works that provide both geothermal energy supply and structural support to the built environments. This research work is driven by the ...

EPFL2021

Page 2 of 2